Majacraft Drive Band – Aura Black Fabric Belt
Canadian shipping only.
Black “fabric” belt that drives the bobbin on the Aura spinning wheel. For the green polycord belt that goes around the drive wheel, order the Suzie band.
PRODUCT of NEW ZEALAND
1 in stock
Hackle, Majacraft – 2 row 320mm
Double pitch hackle from Majacraft, 320 mm (12.6") comb width. The combs have stainless steel pins with polished points that are blunt enough to be much more pleasant to use and sharp enough to do the job well. Fibres are lashed on to the teeth and then pulled through a diz to prepare them into top for spinning. They can be used in much the same way as wool combs, for either preparing a single type of fibre, blending colours or blending a mixture of fibres.
Instead of drilling the hackle base, Majacraft has developed a new technique of bonding the pins in with a very tough resin. The pins are positioned perfectly straight and perfectly even on every hackle.
This is the double row version, and we can order in the single row as well, just inquire for current pricing and availability. It includes a wooden pin cover to protect you and the hackle when it is not in use. Also included are special Majacraft clamps. The clamp block is drilled at an angle and has a solid rubber top to ensure that the hackle is held firmly on your table and the rubber will prevent damage to the table. The clamps allow you to secure the hackle to a sturdy surface and carry out colour blending in conjunction with a diz. The hackle is also stepped at the end to provide an area to use an 'F' clamp if you prefer this to the included clamps.
The hackle dimensions are:
length, 470mm (18.5 inches)
width, 45mm (1.8 inches)
height, 35mm (1.4 inches)
comb width, 320mm (12.6 inches)
The double row hackle is great for finer fibres. The pins are at different heights so initial combing can be done on the higher pins before carrying out fine combing with both rows of pins. As is often the case, the time spent in preparation is taken from the time spent in spinning later.
Majacraft Flyer – Aura Hybrid
Feb/2012 - Majacraft has just announced they are making the new Aura wheel flyer available. This strange-looking beast will fit all the wheel models, and uses the wooden jumbo bobbins that most of us have with the plying kit. It does NOT matter if your jumbo bobbins are the new ones with the two holes. That's important for the Aura wheel but the flyer works perfectly fine with the older version of jumbo bobbins.
In Majacraft's words: "The flyer is all new and builds on the advances Majacraft has made in the past. It shares the aerodynamic shape of our other flyers for efficient and easy spinning. Most importantly it has a new dual function orifice. Fine yarns can be held still in the delta part of the orifice. This also has the function of holding coil yarns very still so you can observe your work. You can bypass the delta and use the large halo ring for spinning huge."
If you splurge and get this flyer, you're going to need a couple of jumbo bobbins if you plan to ply.
NOTE: LITTLE GEM WHEELS require the special Little Gem Mini Tension Knob with any of Majacraft's wide flyers, including the Aura, Plying or Wild flyers. That's because the standard tension knob sticks out too far and gets in the way of the wider flyer arms. It's listed here below the various flyers and flyer kits. We usually keep it in stock.